.::Changing your dash lights::.
.::What you need::.
1. Screwdriver (phillips and a small flat
head)
2. Scissors
3. Whatever color gel you want
4. Instructions on how
to take your center dash out
5. Small sharp knife
.::What to do::.
1. Go to the HU removal DIY and take your
center dash out.
2. Remove the heating/AC knobs by pulling on them
3.
Remove the three screws shown below
4. Set the part you just took off aside
and find the orange "gels"
5. Use your knife to pry those bad boys out but be
careful no to damage them
6. Get the knobs you took off and do the same thing
you just did (careful with these... they go flying)
7. Take the orange gels
you just took out and stick them onto the gel you bought and cut them
out
8. Take the gels you just cut out and
slap them in
9. Put it all back together!!
.::Changing your gauge color::.
.::What you need::.
To do this you need the same tools as above.
.::What to do::.
1. First take a phillips head screwdriver and
remove the two screws
on the top of the gauge area. (you should see
them)
2. Use the "Almighty Force" to pull that part out.
3. Remove the
gauge faces.
4. Pry the edge of the orange Gel off of the back of the gauge
faces and peel them off.
5. You should be able to figure out what to do from
here... if not... go slam your head in a door.
I will get pictures up as
soon as i get them!!